Projet de travail approuvé
ISO/AWI 26678
Ultra-high-molecular-weight polyethylene (PE-UHMW) and High-molecular-weight polyethylene (PE-HMW) pipes, fittings and assemblies — Determination of melt volume-flow rate
Numéro de référence
ISO/AWI 26678
ISO/AWI 26678
Edition 1
© ISO 2026
Projet de travail approuvé
Résumé
This document specifies a method for determining the melt volume-flow rate (MVR) of some Ultra-high-molecular-weight polyethylene (PE-UHMW) and High-molecular-weight polyethylene (PE-HMW) pipes, fittings and assemblies using a die with a bore diameter of 3,628 mm. This document is applicable to the measurement of the melt volume flow rate of PE-UHMW and PE-HMW pipes, fittings and assemblies under the conditions of 230℃/21.6kg where the melt volume flow rate is greater than or equal to 0.1 cm3/10 min. This document is also applicable for the determination of the melt volume flow rate of other thermoplastics, such as polyethylene (PE) materials, polypropylene (PP) etc. pipes, fittings and assemblies.
Informations générales
-
État actuel: ProjetStade: Nouveau projet enregistré au programme de travail du TC/SC [20.00]
-
Edition: 1
-
Comité technique :ISO/TC 138/SC 5
- RSS mises à jour
