ISO 16063-12:2002 Preview

Methods for the calibration of vibration and shock transducers -- Part 12: Primary vibration calibration by the reciprocity method

This part of ISO 16063 specifies the instrumentation and procedures to be used for primary calibration of accelerometers using the reciprocity method and the SI system of units.

It is applicable to the calibration of rectilinear accelerometers over a frequency range of 40 Hz to 5 kHz and a frequency-dependent amplitude range of 10 m/s2 to 100 m/s 2 and is based on the use of the coil of an electrodynamic vibrator as the reciprocal transducer.

Calibration of the sensitivity of a transducer can be obtained using this part of ISO 16063 provided that the signal conditioner or amplifier used with the transducer during calibration has been adequately characterized. In order to achieve these measurement uncertainties, it has been assumed that the transducer has been calibrated in combination with its signal conditioner or amplifier (the combination of which in this part of ISO 16063 is referred to as the accelerometer).


General information

  • Current status : Published
    Publication date : 2002-04
  • Edition : 1
    Number of pages : 20
  • :
    ISO/TC 108/SC 3
    Use and calibration of vibration and shock measuring instruments
  • 17.160
    Vibrations, shock and vibration measurements

Buy this standard

Format Language
PDF
Paper
  • CHF118

Got a question?

Check out our FAQs


Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)

Life cycle

A standard is reviewed every 5 years



Revisions / Corrigenda