ISO/TS 10303-1647:2019
ISO/TS 10303-1647:2019



ISO/TS 10303-1647:2019 specifies the application module for Assembly physical interface requirement.

The following are within the scope of ISO/TS 10303-1647:2019:

the representation of the information needed to describe the manner by which an electronic assembly shall mechanically interface to the next higher assembly. The type of mating connector and its location relative to the electronic assembly are provided as a design requirement, that must be satisfied in the design. The module includes representation of the information needed to describe a physical layer of a communication protocol at a connector interface level.

  • mating connector location;
  • design volume description;
  • physical protocol layer description including connector pinout mapping to signal names;

General information 

  •  : Published
     : 2019-11
  •  : 4
     : 11
  •  : ISO/TC 184/SC 4 Industrial data
  •  :
    25.040.40 Industrial process measurement and control

Buy this standard

This collection is a standard for the exchange of product model data (STEP) module and resource library (SMRL). It is intended for those who are considering adopting ISO 10303 modular application protocols, application modules, and resource parts, or systems built on them, for product data representation …

Got a question?

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)