Abstract
PreviewThis document describes the data link layer (DLL) and physical layer (PHY) for the two CAN-based network interfaces specified in the 11992-series.
The DLL sub-clauses are composed of:
— DLL protocol entity requirements;
— DLL device interface requirements; and
— DLL network system requirements.
Normally, the physical signalling sub-layer is implemented in the CAN protocol controller. The physical medium attachment sub-layer is normally implemented in the CAN transceiver or the System Base Chip (SBC). Optionally, it can comprise also additional protection circuitry. The media-dependent sub-layer comprises the connectors and the cabling.
The physical signalling (PS) sub-clauses are composed of:
— PS entity requirements;
— PS device interface requirements; and
— PS network system requirements.
The physical medium attachment (PMA) sub-clauses are composed of:
— PMA protocol entity requirements; and
— PMA device interface requirements.
The physical medium dependent (PMD) sub-clauses are composed of:
— PMD entity requirements;
— PMD device interface requirements; and
— PMD network system requirements.
-
Status: PublishedPublication date: 2019-05
-
Edition: 3Number of pages: 22
-
- ICS :
- 43.040.15 Car informatics. On board computer systems
Buy this standard
| Format | Language | |
|---|---|---|
| std 1 124 | PDF + ePub | |
| std 2 124 | Paper |
- CHF124
Life cycle
-
Previously
WithdrawnISO 11992-1:2003
-
Now
Got a question?
Check out our FAQs
Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)