Тезис Предпросмотр
This document describes the data link layer (DLL) and physical layer (PHY) for the two CAN-based network interfaces specified in the 11992-series.
The DLL sub-clauses are composed of:
— DLL protocol entity requirements;
— DLL device interface requirements; and
— DLL network system requirements.
Normally, the physical signalling sub-layer is implemented in the CAN protocol controller. The physical medium attachment sub-layer is normally implemented in the CAN transceiver or the System Base Chip (SBC). Optionally, it can comprise also additional protection circuitry. The media-dependent sub-layer comprises the connectors and the cabling.
The physical signalling (PS) sub-clauses are composed of:
— PS entity requirements;
— PS device interface requirements; and
— PS network system requirements.
The physical medium attachment (PMA) sub-clauses are composed of:
— PMA protocol entity requirements; and
— PMA device interface requirements.
The physical medium dependent (PMD) sub-clauses are composed of:
— PMD entity requirements;
— PMD device interface requirements; and
— PMD network system requirements.
Общая информация
-
Текущий статус : PublishedДата публикации : 2019-05
-
Версия : 3
-
- ICS :
-
Car informatics. On board computer systems
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
PDF + ePub | ||
Бумажный |
- CHF118
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.