Abstract

ISO/TS 10303-1647:2010-03 specifies the application module for Assembly physical interface requirement.

The following are within the scope of ISO/TS 10303-1647:2010-03:

the representation of the information needed to describe the manner by which an electronic assembly shall mechanically interface to the next higher assembly. The type of mating connector and its location relative to the electronic assembly are provided as a design requirement, that must be satisfied in the design. The module includes representation of the information needed to describe a physical layer of a communication protocol at a connector interface level.

  • mating connector location;
  • design volume description;
  • physical protocol layer description including connector pinout mapping to signal names;


General information 

  • Status
     : Withdrawn
    Publication date
     : 2010-03
  • Edition
     : 2
    Number of pages
     : 8
  • Technical Committee
     : ISO/TC 184/SC 4 Industrial data
  • ICS
     :
    25.040.40 Industrial process measurement and control

Life cycle

Got a question?

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)

  2. Store
  3. Standards catalogue
  4. ICS
  5. 25
  6. 25.040
  7. 25.040.40
  8. ISO/TS 10303-1647:2010