ISO/TS 10303-1647:2006
ISO/TS 10303-1647:2006
Status : Withdrawn
This standard ISO/TS 10303-1647:2010


ISO/TS 10303-1647:2006 specifies the application module for Assembly physical interface requirement.

ISO/TS 10303-1647:2006 deals with the representation of the information needed to describe the manner by which an electronic assembly shall mechanically interface to the next higher assembly. The type of mating connector and its location relative to the electronic assembly are provided as a design requirement that must be satisfied in the design. ISO/TS 10303-1647:2006 includes representation of the information needed to describe a physical layer of a communication protocol at a connector interface level.

The following are within the scope of ISO/TS 10303-1647:2006:

  • mating connector location;
  • design volume description;
  • physical protocol layer description including connector pinout mapping to signal names.

General information

  •  : Withdrawn
     : 2006-12
    : Withdrawal of International Standard [95.99]
  •  : 1
     : 41
  • ISO/TC 184/SC 4
  • RSS updates

Got a question?

Check out our FAQs

Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)