This standard was last reviewed and confirmed in 2018. Therefore this version remains current.
ISO 23711:2003 specifies requirements for materials used for moulded seals made of thermoplastic elastomers (TPEs) for joints in:
- thermoplastic piping systems for non-pressure waste water discharge (intermittent flow at up to 95 °C) inside buildings;
- thermoplastic piping systems for non-pressure underground drainage and sewerage (continuous flow at up to 45 °C and intermittent flow at up to 95 °C);
- thermoplastic rainwater piping systems.
General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design.
Status : PublishedPublication date : 2003-12
Edition : 1Number of pages : 11
Technical Committee:Products (other than hoses)
Buy this standard
A standard is reviewed every 5 years
Revisions / Corrigenda