ISO 10605:2008 Preview

Road vehicles -- Test methods for electrical disturbances from electrostatic discharge

ISO 10605:2008 specifies the electrostatic discharge (ESD) test methods necessary to evaluate electronic modules intended for vehicle use. It applies to discharges in the following cases:

  • ESD in assembly;
  • ESD caused by service staff;
  • ESD caused by occupants.

ESD applied to the device under test (DUT) can directly influence the DUT. ESD applied to neighbouring parts can couple into supply and signal lines of the DUT in the vehicle and/or directly into the DUT.

ISO 10605:2008 describes test procedures for evaluating both electronic modules on the bench and complete vehicles. It also describes a test procedure that classifies the ESD sensitivity of modules for packaging and handling. ISO 10605:2008 applies to all types of road vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor).

ISO 10605:2008 is based in part on IEC 61000-4-2 and describes vehicle-specific requirements.

ISO 10605:2008 does not apply to pyrotechnic modules.


General information

  • Current status : Published
    Publication date : 2008-07
  • Edition : 2
    Number of pages : 50
  • :
    ISO/TC 22/SC 32
    Electrical and electronic components and general system aspects
  • 43.040.10
    Electrical and electronic equipment

Buy this standard

Format Language
PDF
Paper
  • CHF158

Got a question?

Check out our FAQs


Customer care
+41 22 749 08 88

Opening hours:
Monday to Friday - 09:00-12:00, 14:00-17:00 (UTC+1)