This standard was last reviewed and confirmed in 2018. Therefore this version remains current.
ISO 6520-2:2013 collects and classifies the possible imperfections in welds made with pressure. A uniform designation is specified. Only the type, shape, and dimensions of the different imperfections caused by welding with pressure are included. Metallurgical deviations are not taken into account. Imperfections produced other than by the welding operation, e.g. additional stresses, loads or environmental factors, are not covered by ISO 6520-2:2013.
Information concerning the consequences of the imperfections mentioned and the use of particular structures is not given, because this depends on the specific requirements of the joint.
Status : PublishedPublication date : 2013-08
Edition : 2Number of pages : 26
Technical Committee:Representation and terms
Buy this standard