Это стандарт пересмотрен ISO 13259:2020
Тезис
This document specifies a test method for determining the leak tightness of elastomeric sealing ring type joints for buried thermoplastics non-pressure piping systems.
Unless otherwise specified in the referring standard, the tests are carried out at the following basic test pressures:
— p1: internal negative air pressure (partial vacuum);
— p2: a low internal hydrostatic pressure;
— p3: a higher internal hydrostatic pressure.
It also describes the following four test conditions under which the tests are performed:
a) Condition A: without any additional diametric or angular deflection;
b) Condition B: with diametric deflection;
c) Condition C: with angular deflection;
d) Condition D: with simultaneous angular and diametric deflection.
The applicable selection of the test pressure(s) and the test condition(s) is specified in the referring standard
Общая информация
-
Текущий статус : WithdrawnДата публикации : 2018-04
-
Версия : 2
-
Технический комитет:Plastics pipes and fittings for soil, waste and drainage (including land drainage)
-
- ICS :
-
Plastics pipes
-
Drainage systems
Жизненный цикл
-
Ранее
WithdrawnISO 13259:2010
-
Сейчас
Исправления / Изменения
DeletedISO 13259:2018/CD Amd 1
-
Пересмотрен
PublishedISO 13259:2020
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.