ISO 11952:2019 Предпросмотр

Surface chemical analysis -- Scanning-probe microscopy -- Determination of geometric quantities using SPM: Calibration of measuring systems

недоступно на русском языке

This document specifies methods for characterizing and calibrating the scan axes of scanning-probe microscopes (SPMs) for measuring geometric quantities at the highest level. It is applicable to those providing further calibrations and is not intended for general industry use, where a lower level of calibration might be required.

This document has the following objectives:

— to increase the comparability of measurements of geometrical quantities made using SPMs by traceability to the unit of length;

— to define the minimum requirements for the calibration process and the conditions of acceptance;

— to ascertain the instrument's ability to be calibrated (assignment of a "calibrate-ability" category to the instrument);

— to define the scope of the calibration (conditions of measurement and environments, ranges of measurement, temporal stability, transferability);

— to provide a model, in accordance with ISO/IEC Guide 98-3, to calculate the uncertainty for simple geometrical quantities in measurements using an SPM;

— to define the requirements for reporting results.


Общая информация

  • Текущий статус :  Published
    Дата публикации : 2019-05
  • Версия : 2
    Число страниц : 58
  • :
    ISO/TC 201/SC 9
    Scanning probe microscopy
  • 71.040.40
    Chemical analysis

Приобрести данный стандарт

Формат Язык
PDF + ePub
Бумажный
  • CHF178

Жизненны цикл

Стандарт, который пересматривается каждые 5 лет



Изменения / Исправления

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах

Subscribe