Тезис Предпросмотр
ISO 4437-1:2014 specifies the general properties of polyethylene (PE) compounds for the manufacture of pipes and fittings intended to be used for the supply of gaseous fuels.
It also specifies the test parameters for the test methods referred to in this International Standard.
In conjunction with ISO 4437-2, ISO 4437-3, ISO 4437-4, and ISO 4437-5, it is applicable to PE pipes, fittings and valves, their joints, and joints with components of PE and other materials intended to be used under the following conditions: the maximum operating pressure (MOP) is based on the design stress determined from the compound minimum required strength (MRS) divided by the C factor, and taking into account rapid crack propagation (RCP) requirements; and a temperature of 20 °C is taken as reference temperature for the design basis.
Общая информация
-
Текущий статус : PublishedДата публикации : 2014-01
-
Версия : 1
-
- ICS :
-
Petroleum products and natural gas handling equipment
-
Plastics pipes and fittings for non fluid use
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
PDF + ePub | ||
Бумажный | ||
- CHF88
Жизненный цикл
-
Ранее
WithdrawnISO 4437:2007
-
Сейчас
PublishedISO 4437-1:2014
Стандарт, который пересматривается каждые 5 лет
Этап: 90.92 (Будет пересмотрено) -
Будет заменено
Under developmentISO/DIS 4437-1
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.