Тезис 

ISO/TS 10303-1635:2010-03 specifies the application module for Assembly functional interface requirement.

The following are within the scope of ISO/TS 10303-1635:2010-03:

    the representation of the information needed to describe the manner by which an electronic assembly shall electrically or functionally interface to the next higher assembly.

    Constraints on the signals associated with terminals of the mating connector may be specified.

    Identification of the mating terminals is supported. This module defines the information needed to describe the physical layer of an engineering operational protocol and the mapping of the signals in the protocol definition to a terminal in the usage view of the product. Support for functional characterization of the host connector, media connector or media is provided.

  • signal names for assembly terminals;
  • physical layer protocol definition;
  • external functional characterization of a connector or media referenced in a protocol definition.


Общая информация

  • Текущий статус :  Withdrawn
    Дата публикации : 2010-03
  • Версия : 2
  • :
    ISO/TC 184/SC 4
    Industrial data
  • 25.040.40
    Industrial process measurement and control

Жизненный цикл

Стандарт, который пересматривается каждые 5 лет



Изменения / Исправления

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)

Будьте в курсе актуальных новостей ИСО

Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.