Последний раз этот стандарт был пересмотрен в 2012. Поэтому данная версия остается актуальной
Тезис Предпросмотр
1 Scope
This standard gives requirements and test methods for rubber and plastics suction hoses for fire-fighting purposes.
NOTE 1 All pressures are expressed in megapascals. 1 MPa = 10 bar.
Additional requirements are specified for hose assemblies, that is, hoses with couplings already fitted, where this is carried out by the hose manufacturer (see clause 8).
Type A (Rubber) hoses are intended for use at a minimum temperature of -20 _ C and Type B (Thermoplastics) hoses are intended for use at a minimum temperature of -10 _ C.
NOTE 2 Hoses for use at temperatures lower than those specified above can be supplied by agreement between the manufacturer and purchaser. In this case, the low temperature flexibility test (see 6.3) should be carried out at the specified temperature.
RTF report excerpt
! RTF: element uses bad font `MSTT31C69400´ with content ...m temperature of -20'_ 'C and Type B (Thermo...
! RTF: element uses bad font `MSTT31C69400´ with content ...m temperature of -10'_ 'C....
Общая информация
-
Текущий статус : PublishedДата публикации : 2002-12
-
Версия : 1
-
- ICS :
-
Fire-fighting
-
Hoses
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
Бумажный |
- CHF88
Жизненный цикл
-
Сейчас
PublishedISO 14557:2002
Стандарт, который пересматривается каждые 5 лет
Этап: 90.92 (Будет пересмотрено)Исправления / Изменения
PublishedISO 14557:2002/Amd 1:2007
-
Будет заменено
Under developmentISO/FDIS 14557
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.