Последний раз этот стандарт был пересмотрен в 2019. Поэтому данная версия остается актуальной
Тезис Предпросмотр
ISO 6145-8:2005 specifies a dynamic method using diffusion for the preparation of calibration gas mixtures containing component mole fractions ranging from 10-9 to 10-3. A relative expanded uncertainty of measurement, U, obtained by multiplying the relative combined standard uncertainty by a coverage factor k = 2, of not greater than ± 2 % can be achieved by using this method.
By keeping the path between the diffusion source and place of use as short as possible, the method can be applied for the generation of low-concentration calibration gases of organic components that are liquid at room temperature, with boiling points ranging from about 40 °C to 160 °C.
ISO 6145-8:2005 is applicable not only for the generation of calibration gas mixtures of a wide range of hydrocarbons at ambient and indoor air concentration levels, but also for the generation of low-concentration gas mixtures of water.
Общая информация
-
Текущий статус : PublishedДата публикации : 2005-02
-
Версия : 1Число страниц : 19
-
- ICS :
-
Chemical analysis
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
Бумажный |
- CHF118
Жизненны цикл
Стандарт, который пересматривается каждые 5 лет
Изменения / Исправления
-
Не подтверждено
ISO 6145-8:2005
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах