Тезис Предпросмотр
ISO 4126-9:2008 covers the application and installations of safety devices such as safety valves, safety valves and bursting disc safety devices in combination, pilot-operated safety valves and controlled safety pressure-relief systems for the protection of pressure equipment. ISO 4126-6 covers the selection, application and installation of bursting disc safety devices.
ISO 4126-9:2008 describes the normative requirements for applications and installations of safety devices to protect static pressure equipment. The information contained in ISO 4126-9:2008 assumes single-phase flow of the fluid discharged from the safety device. ISO 4126-10 provides guidance specific to two-phase flow conditions.
Equipment connected together in a system by piping of adequate capacity, which is free from potential blockages and does not contain any valve that can isolate any part, can be considered to be a safety system for the application of pressure relief.
ISO 4126-9:2008 does not deal with other safety devices, such as safety related monitoring, control and regulation devices and other limiting devices allowed by some national regulations.
Общая информация
-
Текущий статус : PublishedДата публикации : 2008-04
-
Версия : 1
-
- ICS :
-
Protection against excessive pressure
Приобрести данный стандарт
| Формат | Язык | |
|---|---|---|
| Бумажный |
- CHF138
Жизненный цикл
-
Сейчас
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.