Последний раз этот стандарт был пересмотрен в 2017. Поэтому данная версия остается актуальной
Тезис Предпросмотр
The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.
Общая информация
-
Текущий статус : PublishedДата публикации : 1995-02
-
Версия : 1
-
Технический комитет:General properties of pipes, fittings and valves of plastic materials and their accessories -- Test methods and basic specifications
-
- ICS :
-
Plastics pipes
-
Plastics fittings
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
Бумажный |
- CHF38
Жизненный цикл
-
Ранее
WithdrawnISO 2507:1982
-
Сейчас
PublishedISO 2507-1:1995
Стандарт, который пересматривается каждые 5 лет
Этап: 90.93 (Подтверждено)
Появились вопросы?
Ознакомьтесь с FAQ
Работа с клиентами
+41 22 749 08 88
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.