Фильтр :
| Стандарт и/или проект находящийся в компетенции ISO/TC 131/SC 2 Секретариата | Этап | ICS |
|---|---|---|
|
ISO 3019-1:1975 [Отозвано]
Hydraulic fluid power — Positive displacement pumps and motors — Dimensions and identification code for mounting flanges and shaft ends — Part 1: Inch series shown in metric units
|
95.99 | |
|
Hydraulic fluid power — Dimensions and identification code for mounting flanges and shaft ends of displacement pumps and motors — Part 1: Inch series shown in metric units
|
90.93 | |
|
ISO 3019-2:1986 [Отозвано]
Hydraulic fluid power — Positive displacement pumps and motors — Dimensions and identification code for mounting flanges and shaft ends — Part 2: Two- and four-hole flanges and shaft ends — Metric series
|
95.99 | |
|
Hydraulic fluid power — Dimensions and identification code for mounting flanges and shaft ends of displacement pumps and motors — Part 2: Metric series
|
90.93 | |
|
Hydraulic fluid power — Dimensions and identification code for mounting flanges and shaft ends of displacement pumps and motors — Part 2: Metric series — Technical Corrigendum 1
|
60.60 | |
|
ISO 3019-3:1981 [Отозвано]
Hydraulic fluid power — Positive displacement pumps and motors — Dimensions and identification code for mounting flanges and shaft ends — Part 3: Polygonal flanges (including circular flanges)
|
95.99 | |
|
ISO 3019-3:1988 [Отозвано]
Hydraulic fluid power — Positive displacement pumps and motors — Dimensions and identification code for mounting flanges and shaft ends — Part 3: Polygonal flanges (including circular flanges)
|
95.99 | |
|
Hydraulic fluid power — Pumps and motors — Geometric displacements
|
90.20 | |
|
Hydraulic fluid power — Pumps, motors and integral transmissions — Parameter definitions and letter symbols
|
90.20 |
По запросу ничего не найдено. Пожалуйста, попробуйте изменить настройки фильтра.