• Фильтр:

  •  
  •  
  •  
  •  
Стандарт и/или проект Этап ТК
ISO 14:1982
Straight-sided splines for cylindrical shafts with internal centering -- Dimensions, tolerances and verification
90.93 ISO/TC 14
ISO/R 773:1969
Rectangular or square parallel keys and their corresponding keyways (Dimensions in millimetres)
95.99 ISO/TC 14
ISO/R 774:1969
Taper keys with or without gib head and their corresponding keyways (Dimensions in millimetres)
95.99 ISO/TC 14
ISO/R 775:1969
Cylindrical and 1/10 conical shaft ends
95.99 ISO/TC 14
ISO/R 775:1969/Add 1:1974
Checking of the depth of keyways in conical shaft ends
95.99 ISO/TC 14
ISO 2491:1974
Thin parallel keys and their corresponding keyways (Dimensions in millimetres)
95.99 ISO/TC 14
ISO 2492:1974
Thin taper keys with or without gib head and their corresponding keyways (Dimensions in millimetres)
95.99 ISO/TC 14
ISO 3117:1977
Tangential keys and keyways
90.93 ISO/TC 14
ISO 3912:1977
Woodruff keys and keyways
90.93 ISO/TC 14
ISO 4156:1981
Straight cylindrical involute splines -- Metric module, side fit -- Generalities, dimensions and inspection
95.99 ISO/TC 14
ISO 4156:1981/Amd 1:1992
Section three: Inspection
95.99 ISO/TC 14
ISO 4156-1:2005
Straight cylindrical involute splines -- Metric module, side fit -- Part 1: Generalities
90.92 ISO/TC 14
ISO/WD 4156-1
Straight cylindrical involute splines -- Metric module, side fit -- Part 1: Generalities
20.60 ISO/TC 14
ISO 4156-2:2005
Straight cylindrical involute splines -- Metric module, side fit -- Part 2: Dimensions
90.92 ISO/TC 14
60.60 ISO/TC 14
ISO/WD 4156-2
Straight cylindrical involute splines -- Metric module, side fit -- Part 2: Dimensions
20.60 ISO/TC 14
ISO 4156-3:2005
Straight cylindrical involute splines -- Metric module, side fit -- Part 3: Inspection
90.92 ISO/TC 14
ISO/WD 4156-3
Straight cylindrical involute splines -- Metric module, side fit -- Part 3: Inspection
20.60 ISO/TC 14
ISO 6413:1988
Technical drawings -- Representation of splines and serrations
95.99 ISO/TC 10/SC 6
ISO 6413:2018
Technical product documentation -- Representation of splines and serrations
60.60 ISO/TC 10/SC 6

По запросу ничего не найдено