ISO 10605:2008
Road vehicles -- Test methods for electrical disturbances from electrostatic discharge
Media and price
| Language | Format | Add to basket |
|---|---|---|
| English | PDF (873 kB) | CHF 150,00 |
| English | Paper | CHF 150,00 |
| French | PDF (930 kB) | CHF 150,00 |
| French | Paper | CHF 150,00 |
General information
Number of Pages: 50
| Edition: 2 (Monolingual) | ICS: 43.040.10 |
| Status: Published | Stage: 60.60 (2008-07-07) |
| TC/SC: TC 22/SC 3 |
Abstract
ISO 10605:2008 specifies the electrostatic discharge (ESD) test methods necessary to evaluate electronic modules intended for vehicle use. It applies to discharges in the following cases:
- ESD in assembly;
- ESD caused by service staff;
- ESD caused by occupants.
ESD applied to the device under test (DUT) can directly influence the DUT. ESD applied to neighbouring parts can couple into supply and signal lines of the DUT in the vehicle and/or directly into the DUT.
ISO 10605:2008 describes test procedures for evaluating both electronic modules on the bench and complete vehicles. It also describes a test procedure that classifies the ESD sensitivity of modules for packaging and handling. ISO 10605:2008 applies to all types of road vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor).
ISO 10605:2008 is based in part on IEC 61000-4-2 and describes vehicle-specific requirements.
ISO 10605:2008 does not apply to pyrotechnic modules.
Revision information
Revises: ISO 10605:2001
These standards could also interest you
-
ISO 22900-3:2009
Road vehicles -- Modular vehicle communication interface (MVCI) -- Part 3: Diagnostic server application programming interface (D-Server API) -
ISO 10924-4:2009
Road vehicles -- Circuit breakers -- Part 4: Medium circuit breakers with tabs (Blade type), Form CB15 -
ISO 10924-1:2009
Road vehicles -- Circuit breakers -- Part 1: Definitions and general test requirements
News feeds
