Home

ISO 6145-4:2004
Subscribe to updates

Gas analysis -- Preparation of calibration gas mixtures using dynamic volumetric methods -- Part 4: Continuous syringe injection method

This standard has been reviewed* and then confirmed in 2008.

*ISO standards are reviewed every five years.

Abstract

ISO 6145-4:2004 specifies a method for continuous production of calibration gas mixtures, containing two or more components, from pure gases or other gas mixtures by continuous injection of the calibration component(s) into a complementary gas stream by means of a syringe.

If pre-mixed gases are used instead of pure gases (see Annex A), much lower volume fractions can be obtained. The volume flow rates, from which the volume fractions are determined, can be calculated from the individual flow rates and can be independently measured by a suitable method given in ISO 6145-1.

The merits of the method are that a substantial quantity of the gas mixture can be prepared on a continuous basis and that multi-component mixtures can be prepared almost as readily as binary mixtures if the appropriate number of syringes is utilized, or if the syringe already contains a multi-component mixture of known composition. This method also provides a convenient means for increasing the volume fraction of the calibration component in the mixture in small steps. It is therefore a useful method for evaluation of other characteristics of gas analysers, such as minimum detection limit and dead zone, as well as accuracy. The relative expanded uncertainty in the volume fraction obtainable for a binary mixture (at a coverage factor of 2) is 5 % and the range of applicability is 10-5 to 10-2.

 

Related standards

Format
  • PDF

    This format preserves the paper layout, and is watermarked

  • EPUB

    This format allows documents to be read on tablets and smartphones

  • COLOUR PDF

    Enhanced user-friendly colour PDF format

  • PAPER

    Normally A4 size documents. Shipping costs apply

Language
PDF
Paper

Swiss francs CHF 88

Add to basket

Contact customer services

Send your enquiry by email
or call us on +41 22 749 08 88
09:00 – 12:30, 14:00 – 17:00 (UTC+1).