Plastics piping systems for non-pressure drainage and sewerage -- Polyester resin concrete (PRC) -- Part 1: Pipes and fittings with flexible joints
(Only available in English)
This standard was last reviewed and confirmed* in 2014.
ISO 18672-1:2009 specifies definitions, requirements and characteristics of pipes, fittings, joints, materials, test methods and marking for pipes and fittings made from polyester resin concrete (PRC), intended to be used within a drain or sewer system operating without pressure. It applies to products for use in buried installations to be installed by open-trench techniques or pipe jacking.
It applies to pipes, fittings and their joints of nominal sizes from DN 150 to DN 3000 for circular cross-sections, from WN/HN 300/450 to WN/HN 1400/2100 for egg-shaped cross-sections and from DN 800 to DN 1800 for kite-shaped cross-sections.
Document published on: 2009-06-15 Edition: 1 (Monolingual) ICS: 23.040.45; 23.040.20; 91.140.80; 93.030 Status: Published Stage: 90.93 (2014-09-24) TC/SC: ISO/TC 138/SC 6 Number of Pages: 68
This standard has not been revised
No corrigenda or amendments available