Fibre-reinforced plastics -- Methods of producing test plates -- Part 10: Injection moulding of BMC and other long-fibre moulding compounds -- General principles and moulding of multipurpose test specimens
This standard was last reviewed and confirmed* in 2013.
ISO 1268-10:2005 specifies the general principles to be followed while injection moulding test specimens of bulk moulding compound (BMC) and gives details of mould designs for preparing one type of specimen for use in establishing reproducible moulding conditions. Where appropriate, this part of ISO 1268 may be applied to sheet moulding compound (SMC) formulated for injection moulding. Its purpose is to promote uniformity in describing the main parameters of the moulding process and also to establish uniform practice in reporting moulding conditions. The particular conditions required for the reproducible preparation of test specimens which will give comparable results will vary for each material used. These conditions are given in the International Standard for the relevant material or are to be agreed upon between interested parties.
Document published on: 2005-02-01 Edition: 1 (Monolingual) ICS: 83.120 Status: Published Stage: 90.93 (2013-07-23) TC/SC: ISO/TC 61/SC 13 Number of Pages: 16
Revises: ISO 1268:1974
No corrigenda or amendments available