Home

ISO 286-2:2010
Subscribe to updates

Geometrical product specifications (GPS) -- ISO code system for tolerances on linear sizes -- Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts

Abstract

ISO 286-2:2010 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286‑1. ISO 286-2 covers values for the upper limit deviations eU, hole (for holes) and eU, shaft (for shafts) and the lower limit deviations eL, hole (for holes) and eL, shaft (for shafts).

The ISO system for tolerances on linear size provides a system of tolerances and deviations suitable for features of the following types:

  1. cylinders;
  2. two parallel opposite surfaces.

For simplicity, and also because of the importance of cylindrical workpieces of circular section, only these are referred to explicitly. It should be clearly understood, however, that the tolerances and deviations given in ISO 286-2 equally apply to workpieces of other than circular sections.

 

Related standards

Format
  • PDF

    This format preserves the paper layout, and is watermarked

  • EPUB

    This format allows documents to be read on tablets and smartphones

  • COLOUR PDF

    Enhanced user-friendly colour PDF format

  • PAPER

    Normally A4 size documents. Shipping costs apply

Language
PDF
Paper

Swiss francs CHF 178

Add to basket

Contact customer services

Send your enquiry by email
or call us on +41 22 749 08 88
09:00 – 12:30, 14:00 – 17:00 (UTC+1).