This standard has been revised by: ISO 6194-1:2007
This part lays down the nominal dimensions relating to seals suitable for shafts from 6 to 400 mm diameter and accompanying housings from 16 to 440 mm. Seals of this type are not normally suitable for high pressure. Includes dimensional limits for the shafts and housings to assure interchangeability of seals from different manufacturers. The six basic types of seals are described and shown in figure 1. The annex includes a recommended form for reaching agreement between purchaser and manufacturer.
Document published on: 1982-10-01 Edition: 1 (Monolingual) ICS: 23.100.60; 83.140.50 Status: Withdrawn Stage: 95.99 (2007-09-13) TC/SC: ISO/TC 131/SC 7 Number of Pages:
Revised by: ISO 6194-1:2007
No corrigenda or amendments available